Drying Oven

Description

This oven can be widely used in the production of transformer industry, transformer coil impregnation drying (solidifying) process and epoxy pouring solidifying process, etc. Drying oven features high precision temperature control, easy operation, energy saving, safety and high reliability, etc.

Properties

1. As a kind of transformer drying equipment in China, this drying oven can control the whole process automatically.
2. Centrifugal blower with high temperature resistant is installed in this drying oven. The blower make the hot air circulate in the drying oven.
3. It is also equipped with heating chamber in the oven. It can heat the air in the work piece. After that the hot air will exchange in work pieces, then backflow to air duct. Then the air in drying oven can be heated again and circulated in the oven again and again to make the inner temperature meet technological requirements.

Parameters of Drying Oven

Oven body structure
Work space	2000×4000×2000mm(W×L×H)
Outside	Q235 cold rolled steel by anti-rust treatment, spray acrylic air-dry paint
Inside	Q235 cold rolled steel by anti-rust treatment, spray high temperature resistant silver paint
Heat insulating material	silicate cotton insulation
Door open	double-door
Seal material	asbestos rope
Observation window	two sets
Technical data
Operation temperature	Room temperature~200℃
temperature fluctuation	≤±1℃
Temperature stability	≤±2
Temperature uniformity	≤±2.5%℃(max temperature empty test)
temperature rise	≤room temperature+25℃
temperature rate	≤90min(empty test)
heating power	63KW(2 groups)
Blower power	1.5KW×6 sets
Exhaust power	0.75KW×1 set
Power supply	As per customer's request
Blowing system
Air supply mode	bottom to top forced hot air circulation
Air out way	left and right sides bottom
Airflow control	double layer multihole adjusting panel
Air return method	multihole panel on the top of heating chamber
Blower motor	low noise centrifugal blower, noise below 65db
Heating system
Electric heater	star connection 220V 50Hz U-shaped heating tube
Location	in air duct of left and right sides
Control system
Control cabinet	independent type control cabinet
Controller	AI708P programmable intelligent temperature controller with temperature sensing element PT100
Over-temperature alarm	digital temperature controller with temperature sensing element PT100
Heating control	SSR solid state relay contact power adjustment
Lighting	high temperature resistant lights 2 sets
Protect system	1. Over-temperature alarm system 2. Motor over-current protection 3. Electric heater over current protection 4. Electrical and heating interlock 5. Control circuit protection 6. Air switch
Accessories
Intake valve	Manual adjust according to work pieces conditions
Exhaust valve	Manual/automatic intermittent exhaust system, flange interface
Body color	As per customer's request
Work piece trolley	Manual traction, capacity 6 tons, 1 set
Outside guide	For trolley movement